Welcome to Open Science
Contact Us
Home Books Journals Submission Open Science Join Us News
The Use Surface Plasmon Resonance to Determine the Optical Parameters of UV-Adhesive and Control Polymerization Process
Current Issue
Volume 7, 2019
Issue 1 (March)
Pages: 25-29   |   Vol. 7, No. 1, March 2019   |   Follow on         
Paper in PDF Downloads: 6   Since May 28, 2019 Views: 977   Since May 28, 2019
Authors
[1]
Hanna Dorozinska, Faculty of Instrumentation Engineering, National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”, Kyiv, Ukraine.
[2]
Glib Dorozinsky, Department of Physics and Technological Bases of Sensory Materials, V. Lashkaryov Institute of Semiconductor Physics NAS of Ukraine, Kyiv, Ukraine.
[3]
Volodymyr Maslov, Department of Physics and Technological Bases of Sensory Materials, V. Lashkaryov Institute of Semiconductor Physics NAS of Ukraine, Kyiv, Ukraine.
[4]
Natalia Kachur, Department of Physics and Technological Bases of Sensory Materials, V. Lashkaryov Institute of Semiconductor Physics NAS of Ukraine, Kyiv, Ukraine.
Abstract
Ultraviolet adhesives are widely used in the manufacture of precision optical devices. It is known, that adding fillers to the glue reduces shrinkage after polymerization, reduces internal stresses, improves the reliability of the connection, and also allows you to control the optical properties of the connecting layer. By varying the amount and composition of the filler, we can change the refractive index of the compound, as well as improve the processability of the compound due to faster polymerization. The kinetics of polymerization studied on surface plasmon resonance device "Plasmon". We used UV-spectroscopy an fluorescence spectroscopy for investigation glue`s properties. Dependences of the reflection coefficient R on the angle of incidence of laser radiation onto the samples with non-polymerized and polymerized adhesives are measured. The kinetics of polymerization process was determinate. Measurements of the absorption coefficients inherent to the structures glass – adhesive – glass within the range 200…400 nm was performed. The spectra of fluorescence inherent to the structures glass – adhesive – glass within the range 400…700 nm are measured. The obtained results show that the SPR method is informative and can be applied for investigations and optimization of UV-adhesive composition. Introduction of organosilicon acrylates with high dispersion as impurities in these adhesives enables to increase the velocity of adhesive polymerization.
Keywords
Surface Plasmon Resonance, Ultraviolet Adhesive, Polymerization
Reference
[1]
Canovi M., Lucchetti J., Stravalaci M., Re F., Moscatelli D., Bigini P., Salmona M., Gobbi M. Applications of surface plasmon resonance (SPR) for the characterization of nanoparticles developed for biomedical purposes, Sensors. 2012; 12: 16420-16432.
[2]
Ktari T., Baccar H., Mejri M. B., Abdelghani A. Calibration of Surface Plasmon Resonance Imager for Biochemical Detection, International Journal of Electrochemistry. 2012; 2012: 1-5; http://dx.doi.org/10.1155/2012/421692.
[3]
Kylväjä R., Kankainen M., Holm L., Westerlund-Wikström B. Adhesive polypeptides of Staphylococcus aureus identified using a novel secretion library technique in Escherichia coli, BMC Microbiology. 2011; 11: 117-130.
[4]
Mocan L., Ilie I., Matea C., Tabaran F., Kalman E., Iancu C., Mocan T. Surface plasmon resonance-induced photoactivation of gold nanoparticles as bactericidal agents against methicillin-resistant Staphylococcus aureus. International Journal of Nanomedicine. 2014; 9: 1453-1461.
[5]
Decker Ch. Kinetic Study and New Applications of UV Radiation Curing. Macrmolecular rapid communications. 2003, 23 (18): 1067-1093; https://doi.org/10.1002/marc.200290014.
[6]
Kretschmann E., Reather H. Radiative decay of nonradiative surface plasmon excited by light, Z. Naturf. 1968; 23A: 2135-2136.
[7]
www.plasmon.org.ua.
[8]
Gridina N., Dorozinsky G., Khristosenko R., Maslov V., Samoylov A., Ushenin Y., Shirshov Y. Surface Plasmon Resonance Biosensor. Sensors and Transducers. 2013; 149 (2): 60-68.
[9]
Dorozinsky G., Maslov V., Samoylov A., Ushenin Yu. Reducing measurement uncertainty of instruments based on the phenomenon of surface plasmon resonance. American Journal of Optics and Photonics. 2013; 1 (3): 17-22.
[10]
Yurish S. Y. Sensors and Applications in Measuring and Automation Control Systems. Book Series: Advances in Sensors: Reviews, Vol. 4. International Frequency Sensor Association Publishing Ed. Sergey Y. Yurish. 2016.
[11]
Homola J. Surface Plasmon Resonance Based Sensors. Springer-Verlag, 2006.
[12]
Özdemir S. K., Turhan-Sayan G. Temperature effects on surface plasmon resonance: Design considerations for an optical temperature sensor. Journal of Lightwave Technology. 2003, 21(3): 805–814.
[13]
Verri G., Clementi C., Comelli D., Cather Sh., Piqué F. Correction of Ultraviolet-Induced Fluorescence Spectra for the Examination of Polychromy. Applied Spectroscopy. 2008, 62 (12):1295-1302; https://doi.org/10.1366/000370208786822296.
[14]
Fischer H. R., Semprimoschnig Chr., Mooney C., Rohr Th., van Eckc E. R. H., Verkuijlenc M. H. W. Degradation mechanism of silicone glues under UV irradiation and options for designing materials with increased stability. Polymer Degradation and Stability. 2013, 98 (3): 720-726; https://doi.org/10.1016/j.polymdegradstab.2012.12.022.
[15]
Valeur B., Brochon J. C. New trends in fluorescence spectroscopy: applications to chemical and life sciences, 2012.
Open Science Scholarly Journals
Open Science is a peer-reviewed platform, the journals of which cover a wide range of academic disciplines and serve the world's research and scholarly communities. Upon acceptance, Open Science Journals will be immediately and permanently free for everyone to read and download.
CONTACT US
Office Address:
228 Park Ave., S#45956, New York, NY 10003
Phone: +(001)(347)535 0661
E-mail:
LET'S GET IN TOUCH
Name
E-mail
Subject
Message
SEND MASSAGE
Copyright © 2013-, Open Science Publishers - All Rights Reserved